SMC Networks TigerAccess SMC7816M Manuel d'utilisateur télécharger pdf (Page 789)

spanning-tree pathcost method

This command configures the path cost method used for Rapid Spanning

Tree and Multiple Spanning Tree. Use the no form to restore the default.

spanning-tree pathcost method {long | short}

no spanning-tree pathcost method

• long - Specifies 32-bit based values that range from 1-200,000,000.

This method is based on the IEEE 802.1w Rapid Spanning Tree

• short - Specifies 16-bit based values that range from 1-65535.

This method is based on the IEEE 802.1 Spanning Tree Protocol.

Default Setting

Command Mode

Global Configuration

Command Usage

The path cost method is used to determine the best path between

devices. Therefore, lower values should be assigned to ports attached to

faster media, and higher values assigned to ports with slower media.

Note that path cost (page 31-16) takes precedence over port priority

(page 31-18).

Console(config)#spanning-tree pathcost method long

Console(config)#

Pas de commentaire

SMC Networks TigerAccess SMC7816M Manuel d'utilisateur Page 789