SMC Networks TigerAccess SMC7816M Manuel d'utilisateur télécharger pdf (Page 530)

100

101

SNMP C

OMMANDS

21-10

notifications are enabled. If you enter the command with a keyword,

only the notification type related to that keyword is enabled.

•The snmp-server enable traps command is used in conjunction with

the snmp-server host command. Use the snmp-server host

command to specify which host or hosts receive SNMP notifications.

In order to send notifications, you must configure at least one

snmp-server host command.

• The authentication, link-up, and link-down traps are legacy

notifications, and therefore when used for SNMP Version 3 hosts,

they must be enabled in conjunction with the corresponding entries in

the Notify View assigned by the snmp-server group command

(page 21-15).

Example

Related Commands

snmp-server host (21-6)

snmp-server engine-id

This command configures an identification string for the SNMPv3 engine.

Use the no form to restore the default.

Syntax

snmp-server engine-id {local | remote {ip-address}} engineid-string

no snmp-server engine-id {local | remote {ip-address}}

• local - Specifies the SNMP engine on this switch.

• remote - Specifies an SNMP engine on a remote device.

• ip-address - The Internet address of the remote device.

• engineid-string - String identifying the engine ID.

(Range: 1-26 hexadecimal characters for the local engine ID and

10-64 for a remote engine ID)

Default Setting

A unique engine ID is automatically generated by the switch based on

its MAC address.

Console(config)#snmp-server enable traps link-up-down

Console(config)#

1 2 ... 525 526 527 528 529 530 531 532 533 534 535 ... 961 962

Commentaires sur ces manuels

Pas de commentaire

SMC Networks TigerAccess SMC7816M Manuel d'utilisateur Page 530

Commentaires sur ces manuels