SMC Networks TigerAccess SMC7816M Manuel d'utilisateur télécharger pdf (Page 586)

100

101

SER

UTHENTICATION

OMMANDS

22-46

Command Usage

• If anyone tries to access a management interface on the switch from

an invalid address, the switch will reject the connection, enter an event

message in the system log, and send a trap message to the trap

manager.

• IP address can be configured for SNMP, web and Telnet access

respectively. Each of these groups can include up to five different sets

of addresses, either individual addresses or address ranges.

• When entering addresses for the same group (i.e., SNMP, web or

Telnet), the switch will not accept overlapping address ranges. When

entering addresses for different groups, the switch will accept

overlapping address ranges.

• You cannot delete an individual address from a specified range. You

must delete the entire range, and reenter the addresses.

• You can delete an address range just by specifying the start address, or

by specifying both the start address and end address.

Example

This example restricts management access to the indicated addresses.

show management

This command displays the client IP addresses that are allowed

management access to the switch through various protocols.

Syntax

show management {all-client | http-client | snmp-client |

telnet-client}

• all-client - Adds IP address(es) to the SNMP, web and Telnet

groups.

• http-client - Adds IP address(es) to the web group.

• snmp-client - Adds IP address(es) to the SNMP group.

• telnet-client - Adds IP address(es) to the Telnet group.

Console(config)#management all-client 192.168.1.19

Console(config)#management all-client 192.168.1.25 192.168.1.30

Console#

1 2 ... 581 582 583 584 585 586 587 588 589 590 591 ... 961 962

Commentaires sur ces manuels

Pas de commentaire

SMC Networks TigerAccess SMC7816M Manuel d'utilisateur Page 586

Commentaires sur ces manuels