SMC Networks TigerAccess SMC7816M Manuel d'utilisateur télécharger pdf (Page 205)

Web – Specify the action (i.e., Permit or Deny). Specify the source and/or

destination addresses. Select the address type (Any, Host, or IP). If you

select “Host,” enter a specific address. If you select “IP,” enter a subnet

address and the mask for an address range. Set any other required criteria,

such as service type, protocol type, or TCP control code. Then click Add.

Figure 8-3 ACL Configuration - Extended IP

CLI – This example adds three rules:

1. Accept any incoming packets if the source address is in subnet 10.7.1.x.

For example, if the rule is matched; i.e., the rule (10.7.1.0 &

255.255.255.0) equals the masked address (10.7.1.2 & 255.255.255.0),

the packet passes through.

2. Allow TCP packets from class C addresses 192.168.1.0 to any

destination address when set for destination TCP port 80 (i.e., HTTP).

Pas de commentaire

SMC Networks TigerAccess SMC7816M Manuel d'utilisateur Page 205