SMC Networks TigerAccess SMC7816M Manuel d'utilisateur Page 647

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 962
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 646
NEGOTIATION
25-5
negotiation
This command enables autonegotiation for a given interface. Use the no
form to disable autonegotiation.
Syntax
[no] negotiation
Default Setting
Ports 1-16: Permanently disabled
Ports 17-19: Enabled
Command Mode
Interface Configuration (Ethernet - Ports 17-19, Port Channel)
Command Usage
1000BASE-T does not support forced mode. Auto-negotiation
should always be used to establish a connection over any
1000BASE-T port or trunk.
When auto-negotiation is enabled the switch negotiate the best
settings for a link based on the capabilites command. When
auto-negotiation is disabled, you must manually specify the link
attributes with the speed-duplex and flowcontrol commands.
If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (25-6)
speed-duplex (25-3)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
Vue de la page 646
1 2 ... 642 643 644 645 646 647 648 649 650 651 652 ... 961 962

Commentaires sur ces manuels

Pas de commentaire