SMC Networks SMC6724L2GLSC Manuel d'utilisateur télécharger pdf (Page 16)

NSTALLING

THE

ODULE

Handling the Modules

CAUTION: The modules can easily be damaged by electrostatic

discharge.

To prevent electrostatic damage, observe the following guidelines:

• Do not remove the module from its packaging until you are

ready to install it.

•

Do not touch any of the module’s pins, connectors or components

• Hold the module only by its edges or front panel.

• Wear an anti-static wristband connected to a suitable earth

ground whenever handling the module.

• Store or transport this module only in appropriate anti-static

packaging.

Instructions

CAUTION: The switch must be powered off before installing or

replacing any module.

1. Power off the switch: Disconnect the AC power cord from

the switch. If a redundant power unit (RPU) is present,

disconnect its DC cable connection to the switch.

2. Remove network cables: If you are replacing a module,

remove the cable attached to the port on the module.

3. Loosen the screws on the installed module or slot

faceplate: Using your fingers or a flathead screwdriver, turn

the screws securing the module (or faceplate on the slot) in a

counter-clockwise direction until they are free of the chassis.

Be sure not to completely remove the screws from the module

or faceplate.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Pas de commentaire

SMC Networks SMC6724L2GLSC Manuel d'utilisateur Page 16