SMC Networks SMC2670W Manuel d'utilisateur télécharger pdf (Page 10)

1.2 | Resetting the Wireless Ethernet Adapter

To reset the SMC2670W Wireless Ethernet Adapter or to correct

temporary connectivity problems, follow the steps outlined

below:

1. Locate the [Default] button on the back of the EZ Connect

Wireless Ethernet Adapter.

2. Unplug the power from the back of the Wireless Ethernet

Adapter for 5 seconds.

3. Hold down the [Default] button, located on the back of

the device.

4. Plug the power connector into the Wireless Ethernet

Adapter while holding down the [Default] button.

5. Release the [Default] button after 3 seconds.

6. Wait another 3 seconds, and then push and hold down the

[Default] button again.

7. The "LNK/ACT" and "TX/RX" LED indicators will blink once

per second about 10-12 times.

8. When the LED indicators begin flashing rapidly, release the

[Default] button.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Pas de commentaire

SMC Networks SMC2670W Manuel d'utilisateur Page 10