SMC Networks SMC2755W Manuel d'utilisateur télécharger pdf (Page 33)

YSTEM

ONFIGURATION

Using MAC Filter

Set the MAC filter to filter out specified MAC addresses. The Access

Control List (ACL) provides a mechanism to take certain actions

based on the stations MAC address. Any frames with a source or

destination MAC address entered in this table will be filtered from

the Access Point.

How to Setup the Access Control List:

1. Select ACL “Enable.”

2. Enter an ACL ID (1 ~ 60)

3. Enter the MAC address of the station you want to setup.

4. Enter Key Map, should be one of the shared key (1 ~ 4) or one

of the unique key (5 ~ 64), and choose “Allow” or “Deny.” It

means if the station’s WEP key is the same as the Key Map you

assigned, the station will allow connecting to the AP or deny

connecting to the AP.

5. If you just enable the ACL, all stations that have shared keys

can also connect to the AP. If you set the ACL to “Strict,” only

stations that MAC addresses in the ACL can connect to the AP.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Pas de commentaire

SMC Networks SMC2755W Manuel d'utilisateur Page 33