SMC Networks TigerCard 1000 Manuel d'utilisateur télécharger pdf (Page 30)

2-11

NSTALLING

ETWORK

RIVERS

speed: connection speed, 0 auto-negotiate (default)

duplex: duplex mode, 0 auto-negotiate (default), “half” half

duplex, “full” full duplex

3. Assuming the card has been assigned the device name “eth1,”

the following command brings the card into an operational

state:

# ifconfig eth1 up

4. Next the driver must be bound to an active protocol, almost

always TCP/IP, using the following command:

# ifup eth1

Note that this is meaningful only if the system can find a

configuration script that contains the necessary network info. A

sample is given below.

DEVICE=eth0

USERCTL=no

ONBOOT=yes

BOOTPROTO=none

BROADCAST=207.200.5.255

NETWORK=207.200.5.0

NETMASK=255.255.255.0

IPADDR=207.200.5.2

Automatic Installation

This section describes how to install the Linux driver so that it is

automatically loaded and configured at boot time. The following

description is based on the Red Hat 5.1 distribution, but it can be

easily ported to other distributions as well.

Note: Before automatically loading the driver at boot time, be

sure that the system will function correctly after the driver

has been loaded manually.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Pas de commentaire

SMC Networks TigerCard 1000 Manuel d'utilisateur Page 30