SMC Networks SMC6608M Manuel d'utilisateur télécharger pdf (Page 90)

Diagnostic Tests

Upon power-up, the TigerSwitch 100 units perform self-

diagnostic tests (See Chapter 3). Diagnostic tests similar to

those performed on power-up can be run using the Configure

button:

1. Use a long press (>2 seconds) to begin function selection.

The Status LED will start to flash to indicate that functions

may be selected. Use short presses (<2 seconds) to cycle

through the status LEDs until the Diagnostic LED lights. Use

a long press to initiate diagnostic tests.

System Diagnostic Tests

The diagnostic test sequence is performed in two stages. The

first stage is the system diagnostic test. The following table

details system level failures, which are indicated in the

Select/Link row of the LED array:

System Failures

A-3

TROUBLESHOOTING

Component Failure LED Array Indicator Column

System ROM 1

System RAM 2

System EEPROM 3

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 112 113

Pas de commentaire

SMC Networks SMC6608M Manuel d'utilisateur Page 90