SMC Networks SMC2655W Manuel d'utilisateur télécharger pdf (Page 26)

Figure 1.2

Restore to Factory Defaults Procedure

1) Locate the [Default] button on the back of the SMC2655W Access Point.

2) Unplug the power from the back of the AP for 10 seconds.

3) Depress the [Default] button for 3 seconds.

4) Plug the power connector into the AP while depressing the [Default] button.

5) Release the [Default] button after 3 seconds. Wait 3 seconds and then depress the [Default] button again.

6) The "LNK/ACT" and "TX/RX" LEDs will blink once per second about 10-12 times. Release the [Default]

button when these LEDs begin flashing rapidly.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 38 39

Pas de commentaire

SMC Networks SMC2655W Manuel d'utilisateur Page 26