SMC Networks SMC9452TX Manuel d'utilisateur télécharger pdf (Page 21)

NSTALLING

ETWORK

ARD

1-9

Connecting UTP Cable

1. Attach the male RJ-45 connector on one end of a UTP cable to

the network card’s RJ-45 port.

Figure 1-4. Connecting UTP Cable

2. Attach the male connector on the other end of the UTP cable

directly to an Ethernet, Fast Ethernet or Gigabit Ethernet device.

Attach the male connector on the other end of the UTP cable to

a wall outlet with an RJ-45 connector properly wired for

1000BASE-T Gigabit Ethernet. Wiring from the wall outlet

connection is usually routed to a hub or switch through a

punch-down block located in a wiring closet.

3. For 1000 Mbps operation, make certain that the device you are

connecting to is compliant with IEEE 802.3ab 1000BASE-T.

Category 5 Cable

RJ-45 Port

100

1000

LIN

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

Pas de commentaire

SMC Networks SMC9452TX Manuel d'utilisateur Page 21