SMC Networks SMC6724AL2 Manuel d'utilisateur télécharger pdf (Page 40)

NSTALLING

THE

WITCH

3-8

Connecting to a Power Source

To connect a device to a power source:

1. Insert the power cable plug directly into the receptacle located at the

back of the device.

Figure 3-6. Power Receptacle

2. Plug the other end of the cable into a grounded, 3-pin socket.

Note: For International use, you may need to change the AC line cord.

You must use a line cord set that has been approved for the

receptacle type in your country.

3. Check the front-panel LEDs as the device is powered on to be sure

the Power LED is lit. If not, check that the power cable is correctly

plugged in.

100-240V~ 50-60Hz 2A

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 77 78

Pas de commentaire

SMC Networks SMC6724AL2 Manuel d'utilisateur Page 40