Smc-networks SMC EZ Connect Turbo SMC2435W Manuel d'utilisateur télécharger pdf (Page 12)

Step 3: The Device Status shows that "This device is working

properly". If there are any error messages displayed here, you will

need to right-click the SMC adapter and click [Uninstall]. Then reboot

the machine and go through the installation process again.

Utility Installation

NOTE: If you completed [Option #1] to install the drivers, then

you have already installed the utility as well. Please skip to the

next sec-tion. If you completed [Option #2], please complete

the steps below to install the utility.

Step 1: Insert the Driver, Utility and Documentation CD.

Step 2: Click [Start], click [Run] and type [?:\Utility\setup.exe]

(Note: The ? equals the letter of your CD-ROM drive. In most

cases, this is D.)

Step 3: The installation wizard will begin.

Step 4: Click [Next >] to continue.

Step 5: You will be given the option to choose the location

where the Configuration Utility will be installed. It is

recommended to leave this at the default value. Click [Next >]

to continue.

Step 6: Please set the selection to [Yes] and click [Finish] to

reboot the machine. Then once the OS is back up and running,

you should see a new icon in your system tray that launches the

wireless card utility

English

21 22

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Smc-networks SMC EZ Connect Turbo SMC2435W Manuel d'utilisateur Page 12